Saving water is always a good thing. Not only reduce your utility bills but it is also good for the environment. You can easily cut off your water consumption by adjusting the water level in your toilet cisterns. Adjust some of the internal components of the toilet tank, such as your float or replace the larger parts.
Kohler K-4306-G9 Kelston Toilet Bowl, Sandbar
Float operation
A retaining nut located at the bottom of the long fill shaft has the float valve in place. A hose that leads back to the water supply valve on the wall or floor provides water for the valve. The float assembly is connected to the upper part of the float valve. When the water reaches a pre-set level, the filling valve automatically switches off.
Water level
The level of water in the tank provides the energy for the discharge into the container below. The more water in the tank, the greater the power of the discharge. A tube in the center of the tank, called the overflow tube, siphons the excess water when a certain level is reached. This prevents the toilet from overflowing if the float malfunctions.
Rod Float Flex
The float rod extends from the top of the float valve filling valve to the float. The float is usually made of plastic or rubber. The float moves on the surface of the water and carries the rod with it. When a set point is reached, the float causes the rod to lift a handle and cut off the water. It is possible to bend the float valve down to save water in a toilet tank, but that could end up damaging the float rod and care must be taken.
The displacement of water
You can also store water in the toilet without bending the float valve float (and possibly breaking it) by using bricks or a quart containers inside the tank. Fill the fourth container with water (either from the sink or the tank) and set it on the bottom of the tank. You can do the same with a standard brick masonry. Any of these operations will raise the water level in the tank, which effectively cuts the float off before, the same as if the rod is bent.
Replacement of float
Installing a new float valve assembly is probably the best and most efficient way to lower the water level in your manufacturers sell generic tank.Many ballcocks that fit in a number of different toilet models. Some of the new float valve assemblies have a float or o-ring type, which is much easier to adjust than bending a rod. These filling valves have also been built in anti-siphon devices, which codes for construction in your area. It may require.