The elaboration of a double bed frame is a matter of setting the size to match the size of a king frame. By joining a set of three pieces of a double bed frame, with its robust medium support, you can have a good night's sleep without any problems fallen. These frames have six wheels to facilitate their movement. The procedure can be performed in less than 30 minutes.
Zinus Michelle Compack 9-Leg Support Bed Frame, for Box Spring and Mattress Set, Queen
Instructions
1 Adjust the three pieces of the bed frame in their respective places on the floor where your bed is placed. This will allow you to put the frame together and not have to move it too much when finished.
2 Pull the four extension pieces on the two side pieces of the frame. This will allow the connection of each side of the middle support bar. The medium support bar should be similar to the letter "I" with two wheels for easy bed movement. Make sure the extensions are pulled out all the way. Each of them should now look like a letter "C" made of three pieces joined at 90 degree angles. The open sides of the two "C's" should be facing each other.
3 Attach a "C" to the middle section by sliding each of the metal extensions in the middle section in the frame of the clamping device. The clamps are located on each side of the middle section upper and lower arms. Loosely tighten each clamp, since you want to set the bed and base of springs in the frame to ensure a good fit before fully tightening the clamps.
4 Place the two box springs in the frame. (King beds have two double-sized support springs.) If the frame is too small, loosen the clamps and adjust the extensions until the box springs fit together. Adjust each side equally. If the pattern is too large, adjust each side until the sides of the spring box are adjusted with the lip of the frame. You want the middle support that focuses on the bed for maximum comfort while you sleep.
5 Reach under the bed and tighten the clamps so that the frame is safe and not undone when the bed moves. You can deliver to tighten the nuts or use a wrench if they are standard nuts and bolts. If you can not get under the bed, remove the box springs and tighten the clamps, taking care to make sure the frame does not move.