The drive belt on a lawn mower Husqvarna powers The external moving parts, including the clutch system and cutting blades. This drive belt extends around five pulleys on many Husqvarna lawn mowers. To change the tape, it should be removed from the pulleys. However, this can be done only with the mower platform of the lawn mower. Belts wear and thin with time, cracks and breaks gradually. Check the status of the drive belt after every 10 hours of operation.
Instructions
1 Husqvarna lawn Mower Park on a flat work surface. Push the brake pedal while in the brake lever. Pull down on the clutch lever to move it to the "disconnected" setting.
2 Slide the "Off" key on the ignition and pull it. Disconnect the rubber charger from the spark plug wire from the end of the plug. Place the spark plug wire so it will not contact the spark plug during maintenance.
3 push down on the lift lever to lower the cutting platform to its lowest position. Slowly roll the drive belt out of the rear drive pulley and out of the strap fasteners just in front of the pulley. Pull the stabilizer bar retaining spring into the chassis. Push the housing guide out of the bracket.
4 disengage the clutch cable spring from the tensioner arm. Pull the retaining spring from the front Joint Assembly and disconnect the link in front of the mower. Disconnect the suspension arms by pulling the retaining spring out of the brackets. Pull the retaining spring from the rear lift links and disconnect them from the back supports.
5 Pull the cutting platform from under the Husqvarna mower. Roll the chuck pulleys with your hand while pulling the pulley drive belt. Remove belt from tension pulleys. Remove the belt from the cutting platform.
6 Work The new strap in place on both mandrel pulleys and strap guides. Wrap the strap around the two idler pulleys. Put the belt in all the guides. Re-install the cutting platform in the reverse order of its removal. Re-connect the drive belt of the rear drive pulley.