Husqvarna manufactures a series of lawnmowers, which the company refers to as lawn tractors. The company produces cutters with features such as a switch located under the mower's seat that will stop the movement of the paddles as well as the engine as soon as it stands up and leave the mower seat. These lawn tractors also come with hour counter to remind you of important resource needs, which should lead to longer periods without mower problems. If the Husqvarna lawnmower is in trouble, troubleshooting before calling for service.
Instructions
Mower not starting
1 Check that the fuel tank of the mower. Fill it with fuel, if necessary.
2 Move the tractor's free wheel control to "coupled transmission," then enter the seat and push the brake pedal as the mower's parking brake is set. Move attachment clutch A "disconnects" and move regulator control to "choke". Put the key in the ignition of the machine and turn it to "start". Release the key immediately once the mower motor starts. If the mower does not start within 15 seconds after turning the key, set the throttle control to "fast" position, wait two or three minutes and start again.
3 lift the mower seat to access the battery if the mower does not start or start with difficulty. Connect the red voltmeter wire to the positive battery terminal, and connect the black wire to the negative terminal. Read the voltmeter's dial and compare the Volt reading with the voltage posted on the battery itself. If the voltage is lower, release the battery number, recharge or replace it.
Engine does not overturn
4 Push the Husqvarna brake pedal as you attempt to start the engine. The brake pedal must be pressed for the motor to rotate more.
5 Check that the clutch of the mower attachment is not engaged when starting your engine. It's not going to spin over if this clutch has gotten in.
6 Check the battery. Recharge or replace a dead or weak battery.
7 Inspect mower wiring. Tighten all connections and check that all wiring is solid and in good condition. Repair or replace damaged sections or wiring connections.
Low power
8 Raise the blade level of your clipper or reduce the speed as you mow if the machine runs out of power during operation. The lawn mower cannot handle an excessive amount of grass at high speeds.
9 release clutch. Set the parking brake and turn the engine off so that it can be cleaned under the mower. Place the nozzle adapter on the end of the garden hose and then pull the hose lock ring back while pushing the adapter into the wash port on the mower cover. Set aside the locking collar and turn the water supply. Sit on the lawn mower seat. Turn mower in position and throttle to "fast". Attach the clutch while cleaning the cover, and disengage the clutch when finished. Close the mower and remove the garden hose. Allow mower to dry.
10 Remove all fuel from the fuel tank of your clipper If the fuel is dirty. Fill with clean fuel. If the water is present in the fuel, the tank and carburetor must be emptied, refilled with new fuel, and replace the fuel filter on the lawnmower.
Miscellaneous topics
11 Check the blades of your clipper if it is unevenly cut. If any blades are bent or worn, replace them. If loose, tighten blade bolt.
12 Lawn mower Throttle Control Adjustment If you have trouble downloading the machine. Move the accelerator to "fast" and continue to cut.
13 Modify your routine if the motor turns against when it is turned off. After stopping the mower from moving, but before shutting down the engine, set the throttle to a position between half and maximum speed. Shut down the engine.
Tips and warnings
- Wait five to 10 minutes before attempting to start the Husqvarna lawnmower if it has flooded. If you do not have a voltmeter, remove the battery and take it to a auto parts store for testing; A store often provides the service for free.